ページの本文へ

Hitachi

鋳造シミュレーションシステム ADSTEFAN

topImage
Introduction of analysis result
Analysis examples will be introduced about typical shapes such as die casting and gravity casting.
Die-casting/Evaluation of filling behavior in products
充填中の温度分布
Temperature distribution during filling
充填中の空気挙動
Air behavior during filling
初期流入介在物の移動
Movement of initial inclusions
Die-casting/Analysis of Molten Metal Behavior Inside Sleeves
air_contact_time
Air contact time during filling
molten_metal_behavior
Molten Metal Behavior Inside Sleeves
plunger_chip
Temperature distribution of plunger tip
Thixomolding/Evaluation of Cold Shut
contribution
The contribution of each gate
spa_comparison
Defect comparison
Sand casting/Shrinkage analysis
Shrinkage
Shrinkage(Riserφ120mm)
Shrinkage
Defect comparison
Shrinkage
Shrinkage(Riserφ160mm)
Shrinkage
Defect comparison
Sand casting/Comparison of molten metal behavior
Flow
Actual measurement
Flow
Analysis result
Additive Manufacturing/Heat flow analysis during 3D printer stacking
thermal_history
heat_flow
ダウンロード
販売代理店
お問い合わせ